Author |
Message |
Topic: Error 1015: Out of Service Condition Detected |
cairndhu1
Replies: 3
Views: 6800
|
Forum: Tech Help Posted: Sun Jan 05, 2014 8:19 pm Subject: Clear 1015 Err: Partial Safe Clear NO; Full Safe Clear YES |
I guess "reboot" means a "Full Safe Clear" because that procedure cleared the problem.
Background: Machine was left in the middle of a Jacks or Better game when power was turned ... |
Topic: Error 1015: Out of Service Condition Detected |
cairndhu1
Replies: 3
Views: 6800
|
Forum: Tech Help Posted: Sun Jan 05, 2014 6:51 pm Subject: Error 5119: Software Failure; Reboot machine |
Further to the last post, if I put the machine back in service via Configuration, I then get Error 5119 telling me to reboot the machine. Powering down and then up does not help. I could do a Safe Cle ... |
Topic: Error 1015: Out of Service Condition Detected |
cairndhu1
Replies: 3
Views: 6800
|
Forum: Tech Help Posted: Sun Jan 05, 2014 5:25 pm Subject: Error 1015: Out of Service Condition Detected |
Odyssey Manual Solution: Put Machine Back in Service.
Unfortunately, no advice is given as to what is causing the Out of Service Condition so I have no idea where to begin. Any ideas?
Many, many ... |
Topic: Battery on the Mother Board |
cairndhu1
Replies: 2
Views: 8186
|
Forum: Tech Help Posted: Wed Feb 15, 2012 7:56 pm Subject: Battery Replacement |
As Robert said, it's just a matter of popping the old battery out and popping the new battery in. Removing the battery is easy. Inserting the new one required some initiative as it kept slipping from ... |
Topic: LED Diagnostic 0000 |
cairndhu1
Replies: 1
Views: 6198
|
Forum: Tech Help Posted: Wed Feb 15, 2012 12:27 pm Subject: Re: LED Diagnostic 0000 |
My machine, acquired in DEC-01, has been working well (as in a few days ago). Today, however, when I power it up, the LED display shows 0000 and freezes, i.e., there is no boot sequence. Any ideas? Th ... |
Topic: LED Diagnostic 0000 |
cairndhu1
Replies: 1
Views: 6198
|
Forum: Tech Help Posted: Tue Feb 14, 2012 10:40 pm Subject: LED Diagnostic 0000 |
My machine, acquired in DEC-01, has been working well (as in a few days ago). Today, however, when I power it up, the LED display shows 0000 and freezes, i.e., there is no boot sequence. Any ideas? Th ... |
Topic: Bill Acceptor Cannot "See" Bills |
cairndhu1
Replies: 1
Views: 6439
|
Forum: Tech Help Posted: Mon Aug 16, 2010 1:25 pm Subject: Bill Acceptor Cannot "See" Bills Revisited |
Folks, after switching the unit with a spare a couple times, the acceptor now works. Most likely due to a bad contact (at least I hope so). I love my Odysseys (and so do my friends). I hope I can keep ... |
Topic: Bill Acceptor Cannot "See" Bills |
cairndhu1
Replies: 1
Views: 6439
|
Forum: Tech Help Posted: Sun Aug 15, 2010 9:43 pm Subject: Bill Acceptor Cannot "See" Bills |
Slot boots normally and shows 9999. Cash can registers. LEDs are green. ...but acceptor cannot "see" bills. Ideas? Thanks, Jim |
Topic: Anyone Know How to Adjust Monitor Contrast & Color Bala |
cairndhu1
Replies: 2
Views: 7356
|
Forum: Tech Help Posted: Thu Oct 09, 2008 6:09 pm Subject: Monitor Color Problem |
According to Robert: "It appears you have lost the green gun on the monitor, a common problem. That can usually be fixed by repairing the monitor board. The video card inside the computer box i ... |
Topic: Anyone Know How to Adjust Monitor Contrast & Color Bala |
cairndhu1
Replies: 2
Views: 7356
|
Forum: Tech Help Posted: Wed Oct 08, 2008 9:33 pm Subject: Anyone Know How to Adjust Monitor Contrast & Color Bala |
Over the last little while, my yellows have gotten darker and darker until now they are almost orange. Hopefully, there is adjustment somewhere. If so, where and how do I reach it? If not, what do I h ... |
Topic: Bill Validator Failure |
cairndhu1
Replies: 2
Views: 8120
|
Forum: Tech Help Posted: Sun Jun 15, 2008 9:37 pm Subject: Validator Failure Due to Dead GPIO I |
Robert suggested I replace the GPIO I Box with my spare. I did and now everything works again. If anybody has a spare GPIO I Box they would like to sell, please let me know. Thanks, Jim |
Topic: Bill Validator Failure |
cairndhu1
Replies: 2
Views: 8120
|
Forum: Tech Help Posted: Sat Jun 14, 2008 6:26 pm Subject: Bill Validator Failure |
Some time ago the green LEDs on one of my bill validators stopped working and just recently the validator itself stopped working. I have three bill validators. They all work in my King Putt machine; n ... |
Topic: Pump up the Volume |
cairndhu1
Replies: 4
Views: 10900
|
Forum: Tech Help Posted: Sat Jun 14, 2008 6:16 pm Subject: Volume Kill Switch |
My machine also limits volume adjustments to between 85% and 100%. (Apparently, Odyssey did this because the casinos were turning the volume down at night.) In my case, I disconnected the top speaker ... |
Topic: Touch Screen Issues |
cairndhu1
Replies: 4
Views: 11061
|
Forum: Tech Help Posted: Sat Jan 12, 2008 4:41 pm Subject: Touchscreen Issues Continued |
After, over six years, my touchscreen, which was working well in Top Hat, just simply quit when I went back to the Game Menu. I followed Robert's advice below and, much to my pleasant surprise, my tou ... |
Topic: Locks and Keys |
cairndhu1
Replies: 2
Views: 8460
|
Forum: The Trading Post Posted: Sat Jan 12, 2008 3:04 pm Subject: Locks and Keys |
I ordered several from Happ Controls. You can even special order them to be keyed alike. Here's the link:
http://www.happcontrols.com/security/302201xxx.htm |
|