RatherPlayPinball
Joined: 15 Aug 2005 Posts: 52 Location: Michigan
|
Posted: Sun Jun 03, 2007 2:25 pm Post subject: Post Setup Tuning |
|
|
As with any new-in-the-box game, some tuning might be needed. (Not to be interpreted as a complaint, just need some help with some items.)
- There are some black foam bumpers on the playfield that have a peel off film layer - that is already curling and it seems obvious that you should peel the film layer off. But removing the film reveals a black foam that seems sticky. Is this normal?
- One switch (B for Brawl at the top is not working.) Nothing obvious, but I'll keep exploring.
- The 4" BBB logo / sticker on the apron has several large air bubbles in it. Pressing on the bubbles does not make them go away.
- When I open the coin door, it goes into the menu system. Down below, it says something like Info 0, errors 1 - how do you see what it wants? Going into the message area does not reveal what the message/error might be.
- Found a ball trap. Upper right part of playfield, near the single drop target - there is a large enough hole for ball to go into the area under the plastics. Ball search does not let it go.
Any help / suggestions appreciated. What little adjustments have you found?
Jack - #58 |
|
BBB94
Joined: 02 Aug 2005 Posts: 407 Location: WI, USA
|
Posted: Sun Jun 03, 2007 3:33 pm Post subject: |
|
|
I have not gotten to my playfield area yet, so can't help with the black foam yet.
For the air bubbles: if it were mine I would take a sharp needle and poke them and try to push them down from the outside in. |
|