View previous topic :: View next topic |
Author |
Message |
BBB93
Joined: 06 Aug 2005 Posts: 142
|
Posted: Mon Jun 04, 2007 10:32 am Post subject: Tilt Mechanism wiring |
|
|
When setting up my game, I went to attached the plum-bob to the tilt mechanism near the coin box. There are two wires leading rom the tilt mech, one from where the pedulum hangs, and the other from the ring. The two wires lead to a 2 position female connector, but it is not plugged into anything. I do not see any loose wires or comaptible plugs in the area. Could somebody please take a look in their game, comfirm the tilt is plugged into a harness somewhere, and where the wires come from?
Thanks in advance.
Bob S
BBB#93 _________________ Belly-Up To The Big Bang Bar © |
|
Back to top |
|
|
runner1717
Joined: 02 Aug 2005 Posts: 163 Location: Nebraska
|
Posted: Mon Jun 04, 2007 11:39 am Post subject: |
|
|
There should be a two conductor molex with a red/white and two black/white wires attached. The are part of the wire loom on the left cabinet side.
Let me know if you need a picture. _________________ Mike
#61 |
|
Back to top |
|
|
BBB93
Joined: 06 Aug 2005 Posts: 142
|
Posted: Tue Jun 05, 2007 8:17 am Post subject: |
|
|
Yep, found the other end of the connector, it was tucked into the harness and was hiding from me.... Plus, I probably didn't look as hard as I could have, I just wanted to get it set up and play the darn thing.
Thanks!
Bob S
BBB#93 _________________ Belly-Up To The Big Bang Bar © |
|
Back to top |
|
|
|