Big Bang Bar Forum Index Big Bang Bar
Forum hosted by Robert Winter
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Lockdown bar question

 
Post new topic   Reply to topic    Big Bang Bar Forum Index -> General Big Bang Bar Discussions
View previous topic :: View next topic  
Author Message
PL



Joined: 27 Nov 2005
Posts: 9
PostPosted: Tue Jun 19, 2007 8:43 pm    Post subject: Lockdown bar question Reply with quote
Mine is loose and has no screws on the plate it mounts to. Usually games have a screw on each side you adjust?
Back to top
View user's profile Send private message
Cliffy



Joined: 18 Jun 2007
Posts: 25
Location: Bay Area Cal
PostPosted: Tue Jun 19, 2007 9:04 pm    Post subject: Reply with quote
Not that I have an answer for you on that one (but I agree, most games have two leveling screws for the lockdown bar but Capcoms do NOT) but I do want to suggest something else to protect your games. Put a strip of 1/4" x 1/4" dense foam weatherstripping tape inside the bar along the edge that contacts the cabinet. We already notice wear on Kerry's cabinet because the bar rubs the cab there.

For your loose bar all I can suggest is have a look at the latch mechanism itself. The mount holes should have enough room for you to drop the mechanism a bit thereby tightening the bar.
_________________
Cliffy
www.passionforpinball.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Big Bang Bar Forum Index -> General Big Bang Bar Discussions All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group