View previous topic :: View next topic |
Author |
Message |
pinballlew
Joined: 17 May 2007 Posts: 29
|
Posted: Sat Jul 07, 2007 1:27 pm Post subject: Adjusting Pop Bumpers |
|
|
Ok thought I would put this up here before I head to work. Is there a description somewhere on how to adjust the popbumper switch. I checked Clays site but was unable to locate the information if it is there. So does anyone have a online source on how to go about this? If not what is your technique. Thanks -Mike |
|
Back to top |
|
|
Lloyd Olson
Joined: 02 Aug 2005 Posts: 25 Location: Hopkins, Minnesota
|
Posted: Sat Jul 07, 2007 3:49 pm Post subject: |
|
|
POWER OFF. The top point blade with the spoon should just be resting on the pop bumper skirt rod, the bottom point should be about 1/16 of an inch lower. Be sure both points are clean. Then try a game. It may take a time or two to get them so the slightest ball hit triggers the pop bumper, but vibration doesn't ( like flippers or bang on the playfield with your hand. ) After doing it a few times you'll find it easy to get them where you like.
LTG |
|
Back to top |
|
|
|