Big Bang Bar Forum Index Big Bang Bar
Forum hosted by Robert Winter
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Hooking up a computer to grab audits

 
Post new topic   Reply to topic    Big Bang Bar Forum Index -> General Big Bang Bar Discussions
View previous topic :: View next topic  
Author Message
Walter



Joined: 02 Aug 2005
Posts: 15
Location: San Jose, CA
PostPosted: Mon Jul 02, 2007 8:21 am    Post subject: Hooking up a computer to grab audits Reply with quote
Does anyone know what is required to hook up a computer to grab the machine audits? It looks like a special additional board is needed. Does anyone have one or have the schematics?

Thanks,

Walter
#124
Back to top
View user's profile Send private message Send e-mail
The Other Guy



Joined: 04 Feb 2006
Posts: 77
PostPosted: Thu Jul 12, 2007 12:54 pm    Post subject: Reply with quote
Walter,
If I remember correctly, the header to use is on the top left side of the PCB where the coin door cable plugs in.
Also, pin 1 on the header goes to pin 1 of a DB9 (serial) connector. The rest of the pins follow (2-2, 3-3) until #9. Header position 9 is a keyed position, so pin 10 goes to DB9 pin 9.

I think I recollect that that way,
TOG
_________________
"BBB 77"
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Big Bang Bar Forum Index -> General Big Bang Bar Discussions All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group