View previous topic :: View next topic |
Author |
Message |
pinballlew
Joined: 17 May 2007 Posts: 29
|
Posted: Wed Aug 08, 2007 12:03 am Post subject: Not a Software bug |
|
|
I noticed on Tour the Bar when I hit the left orbit that the light doesnt go out and register as a completed shot. Is this a software bug? The switch test fine and works fine in other modes. Thanks -Mike
Last edited by pinballlew on Thu Aug 23, 2007 1:05 am; edited 1 time in total |
|
Back to top |
|
|
pinballlew
Joined: 17 May 2007 Posts: 29
|
Posted: Wed Aug 08, 2007 11:37 pm Post subject: |
|
|
anybody? |
|
Back to top |
|
|
sellenoff
Joined: 07 Aug 2005 Posts: 101
|
Posted: Thu Aug 09, 2007 7:40 am Post subject: |
|
|
pinballlew wrote: | anybody? |
I haven't had a chance to try it on my game, but you can always try it on pinmame and see if it works there. |
|
Back to top |
|
|
runner1717
Joined: 02 Aug 2005 Posts: 163 Location: Nebraska
|
Posted: Thu Aug 09, 2007 4:07 pm Post subject: |
|
|
Mine goes out when in the "tour the bar" mode.
Adjust your orbit switch and check your spinner switch as well. _________________ Mike
#61 |
|
Back to top |
|
|
pinballlew
Joined: 17 May 2007 Posts: 29
|
Posted: Fri Aug 10, 2007 9:45 pm Post subject: |
|
|
I think I figured out the problem. The right orbit gate isn't lifting correctly to feed the orbit. It seems to be binding. I have it all apart but had to walk away and take a break and I am getting ready to go to CA Xtreme tomorrow so I will see what I can do Mon or Tues I didn't realize that it was supposed to so I am going to have to look into fixing this. When I tested it out with the glass off and threw a ball through the left orbit and manually hit the right switch afterwards the light went out. -Mike |
|
Back to top |
|
|
sellenoff
Joined: 07 Aug 2005 Posts: 101
|
Posted: Sun Aug 12, 2007 10:57 am Post subject: |
|
|
I tried it on my BBB and it works fine, ie, the light went out, and the mode registered the shot. |
|
Back to top |
|
|
unigroove
Joined: 08 Aug 2005 Posts: 118
|
Posted: Fri Aug 17, 2007 6:32 am Post subject: |
|
|
Haven't noticed this bug so far. I posted some bugs about a year ago and noticed a new one: After Happy Hour starts all playfield lamps blink for about 5 seconds and then the lamps go back into regular mode while the mode is still running. Anybody else notice this? |
|
Back to top |
|
|
pinballlew
Joined: 17 May 2007 Posts: 29
|
Posted: Thu Aug 30, 2007 10:53 pm Post subject: |
|
|
Alright I figured out the problem. Took me awhile and a task I was unsure if I should try but I took the a lot of parts off and figured out that the right orbit diverter wire was binding against the playfield causing the diverter not to open when it was supposed too. Problem now finally fixed Yeah! Man I was kind of scared removing all the pieces I did but now that I finished my confidence is way up on all Pinball repairs. I now would not be so scared to try a playfield swap. I did have to walk away a couple of times and gather my sanity. Some advice that I picked up from reading Lloyds posts in RGP. I did end up losing a spring to the right diverter but I stole the left one and made a makeshift spring (thanks Mr. Ballpoint pen) for the left one which I stole. Now I just have to figure out where to order the spring (any suggestions?) I also need to order a Darts switch as mine occasionally sticks down. Does anyone know who would carry these? Thanks -Mike |
|
Back to top |
|
|
|