| View previous topic :: View next topic |
| Author |
Message |
marspinball
Joined: 02 Aug 2005
Posts: 49
Location: San Diego, CA
|
 Posted: Sat Oct 20, 2007 8:11 pm Post subject: Foam sticker causing ball drains |
 |
|
I removed the original foam piece on the right side of the lower pop-bumper since it started to lift and directing the ball down the middle.
I installed pinbits rubber parts and their piece for this area was notched. It bulged out a bit and then the lower portion of the foam sticker also became unstuck and again about 50% of the time it drains once it leaves this area.
Am I the only person with this issue?? There has to be a better way to attach some kind of material to this area.
_________________
BBB #131 |
|
| Back to top |
|
 |
martin
Joined: 18 Jun 2007
Posts: 13
|
| Posted: Tue Oct 23, 2007 6:30 pm Post subject: Re: Foam sticker causing ball drains |
|
|
| marspinball wrote: | I removed the original foam piece on the right side of the lower pop-bumper since it started to lift and directing the ball down the middle.
I installed pinbits rubber parts and their piece for this area was notched. It bulged out a bit and then the lower portion of the foam sticker also became unstuck and again about 50% of the time it drains once it leaves this area.
Am I the only person with this issue?? There has to be a better way to attach some kind of material to this area. |
Drop a line to Pam (pamela.reynolds@comcast.net) and we'll send you a replacement. If the glue came loose, there's probably some contamination on the metal so cleaning it up first might help. If it continues to be a problem, you may have to slit the rubber at the notch. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
